Vigo VG06063 User Manual
Page 12
MODEL VG06063
12
FIG.11
9
12
14
H. INSTALLING THE WATER SEAL STRIPS
1.
Clean the door glass panels (#12) edges where the door magnetic seal strips (#9) and the
door bottom seal strips (#14) are to be installed with rubbing alcohol.
2.
Cut the seal strips according to the diagram. [SEE FIG.11] They are pre-cut already but you
may have to cut more to have it fit properly as displayed in the diagram.
3.
Verify that the lips of all seal strips face toward the inside of the shower cabin before seal strip
installation.
4.
Install the seal strips according to the diagram.
THIS SIDE MUST
LOOK INSIDE
THE CABIN
14
13
12
12
9
14
HINGE SIDE
HANDLE SIDE
MAKE SURE TO
MEET THE
BOTTOM OF THE
GLASS
14
NOTES:
1. If the seal strip is not flat and is twisted, soak the strip in hot water and press the seal strip back
into position.
2. Cutting/finishing is needed but only after fully installing and only at the top of the unit.