Vigo VG06063 User Manual
Page 5
STUD
FIG.1
5
MODEL VG06063
PREPARATION STEPS TO FOLLOW BEFORE INSTALLATION
1.
Remove the plastic layer from the base border (if needed). Do NOT remove the plastic layer off the plastic
platform of the base.
2.
Properly apply silicone to the wall and base joints.
3.
Make sure to read corresponding base instructions carefully prior to install on the Vigo Brand Shower Door
System. Failure to do so can cause water leakage and bodily harm.
IMPORTANT
To prevent damage to the finish, you should protect the shower cabin bottom with a cardboard protector
before beginning the installation.
Ensure that there is sufficient structural support behind the shower wall to hold the weight of the shower
door. If there is insufficient support, then reinforce the shower walls with wooden studs prior to shower door
installation. [SEE FIG.1]
CAUTION
!
GASKETS NEED TO BE IN BETWEEN ALL GLASS AND METAL CONTACT. FAILURE TO DO SO
CAN LEAD TO BREAKAGE AND POTENTIAL BODILY HARM.