Explanation of the functions (part 4) – Waldmann PULSE PIR version IV - without MFT User Manual
Page 21
21
Operating manual Light Control „PULSE PIR - Vers. IV“
ENG
Function 2.3
Dual sensors
Function for the adjustment of the
operating mode when used with
an additional presence sensor
(optional accessories).
The default setting of this function
is “OFF”, i.e., the switch-on au-
tomatic works when a presence
is detected by one of the two
sensors.
Both sensors must detect a pre-
sence to turn on the light if this
function is active.
The function can be changed on
lights with sensors XXX /R
Explanation of the functions (part 4)
Fig. 2
LED II
Key II
LED I
Key I
Sensor
Function 2.2
Switch-on automatic
Function to admit or to suppress
automatic switch-on with insuffi-
cient light or in case of presence
(semi-automatic).
The default setting of this function
is ”ON”, i.e., the light is automatical-
ly switched on in case of presence
or insufficient light.
The light has to be switched on ma-
nually even in case presence was
detected if the switch-on automatic
is inactive.
The function can be changed on
lights with sensors XXX /R
Function 2.1
Sensitivity high
Function to change the sensitivity
of the presence control.
The default setting of the function
is “OFF“.
The function cannot be changed.
Note: The functions written
in
blue
are not available.