Change basic settings - part 2 – Waldmann PULSE PIR version IV - without MFT User Manual
Page 9
Advertising
9
Operating manual Light Control „PULSE PIR - Vers. IV“
ENG
Change basic settings - Part 2
Fig. 2
LED II
Key II
LED I
Key I
Sensor
Change setting
The LED I indicates whether a
function is active (ON) or inactive
(OFF) by permanent lighting or
flashing, e.g.:
- LED I permanently lit:
function is active (ON)
- LED I flashing:
function is inactive (OFF)
The function can be activated or
deactivated by using the key I.
Leave parameterisation mode
The parameterisation mode is left
if no switch has been pressed
for 10 seconds. The settings are
stored.
Advertising