Wasp Barcode WDI4600 2D Quick Reference Guide - Manual (Page 12)

Selecting the Interface Type
8 WDI4600
Selecting the Interface Type
Upon completing the physical connection between the reader
and its host, proceed directly to Interface Selection below for
information and programming for the interface type the read-
er is connected to (for example: RS-232, Keyboard Wedge,
USB, etc.) and scan the appropriate barcode to select your sys-
tem’s correct interface type.
Interface Selection
Each reader model will support one of the following sets of
host interfaces:
General Purpose Models: RS-232, RS-232 OPOS, USB, Key-
board Wedge, Wand.
Information and programming options for each interface type
are provided in this section. For defaults and additional infor-
mation associated with each interface, proceed to the corre-
sponding chapter in the WDI4600 PRG.
Configuring the Interface
Scan the appropriate programming barcode to select the inter-
face type for your system.
Unlike some other programming features and options,
interface selections require that you scan only one
programming barcode label. DO NOT scan an ENTER/
EXIT barcode prior to scanning an interface selection
barcode.
Some interfaces require the scanner to start in the dis-
abled state when powered up. If additional scanner
configuration is desired while in this state, pull the
trigger and hold for 5 seconds. The scanner will change
to a state that allows programming with barcodes.