Wasp Barcode WDI4600 2D Quick Reference Guide - Manual (Page 37)

Regulatory Information
Quick Reference Guide 33
Regulatory Information
All models are designed to be compliant with rules and regu-
lations in locations they are sold and will be labeled as re-
quired.
Any changes or modifications to equipment, not expressly ap-
proved by Wasp Barcode Technologies could void the user's
authority to operate the equipment.
Statement of Agency Compliance
This device complies with part 15 of the FCC Rules. Opera-
tion is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must
accept any interference received, including interference that
may cause undesired operation.
FCC Class B Compliance Statement
The user is cautioned that changes or modifications not ex-
pressly approved by the part responsible for compliance could
void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the
limits for a Class B digital device pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential instal-
lation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interfer-
ence will not occur in a particular installation. If this equip-
ment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the inter-
ference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit dif-
ferent from that to which the receiver is connected.
• Consult the dealer or an experienced radio or televi-
sion technician for help.