Weidmuller PTX800D - Scalable pulse and frequency counter - Manual (Page 17)

9
• Modifications
Analogue output type
The analogue output type (current/voltage) is set by internal push fit
jumper. To change the output type:
Change the output type push fit jumper:
1. Gently remove the backplate (it is held in place by four lugs).
. Slide the electronics from the housing.
. Change the jumper location to the required setting (see diagram
above).
. Look inside the housing and note that there are connectors that
mate with the display board.
5. Slide the electronics gently back into the case. Carefully moving the
board until the keypad connectors engage with the display board.
6. Replace the backplate.
Change the output type in the software:
1. Power up the instrument and start the setup routine.
. While the software version number is flashing, remove the security
link and press PGM.
. The display will show Aout_=_y. Press PGM.
. The display will show Aout=volt or Aout=_cur. Select using up
or down key.
5. Replace the security link and press PGM.
Change the output range settings:
6. Scroll through the setup and change the output type and range
settings - you will be required to calibrate the outputs.
Calibrate the output:
. Calibrate the outputs to the new output range and type.