Weidmuller PTX800D - Scalable pulse and frequency counter - Manual (Page 5)


Changing the setup options
You should only use setup mode if you have to change a setting or
calibrate the outputs. The setup mode stops all operation. As soon as
you have setup the last parameter, the unit behaves as if it has been
switched on with the new settings. This does not mean that the total is
reset - you must do this yourself if necessary.
If you want to abandon all the changes you have made, simply remove
the security link (or remove the power) before the save message is
shown.
To change the instrument setup:
1. Connect the security link (short pins 8 & 1).
. Press the PGM key.
The setup sequence is shown in the table on page two.
• Setup options
General
There are four basic areas of the instrument operation that must be
setup on a fully configured PTX800D. They are:
• Pulse/frequency inputs;
• Display and keypad operation;
• Alarms one and two (optional); and
• Analogue outputs (optional).
You can disable the alarms and/or analogue outputs if you do not need
them (so that their settings are skipped).
Software version
The information in this guide refers to versions 1.00 to 1.09.
Model
PTX series instruments all look identical from the front so this identifies
the intrument type.