Western Digital WD Sentinel DX4000 User Manual - Manual (Page 74)

APPENDIX
70 WD SENTINEL DX4000
ADMINISTRATOR’S MANUAL
Disable an iSCSI Target
Note: Disabling your iSCSI Target temporarily suspends the target, but does not remove it.
If you’d like to permanently remove the target, See “Deleting an iSCSI Target” on
page 70.
1. In the iSCSI tab, select the target you’d like to disable.
2. In the iSCSI Tasks pane, click Disable Target. The Disable a Target message appears.
3. Click Disable Target. Disabled now displays in the Status column.
Enabling an iSCSI Target
1. In the iSCSI tab, select the disabled Target you’d like to enable.
2. In the iSCSI Task pane, click Enable Target. Your target is now enabled.
Deleting an iSCSI Target
1. In the iSCSI tab, select the target you’d like to delete.
WARNING! Deleting your iSCSI Target completely removes the target. If you’d
like to temporarily disable the target, See “Disable an iSCSI Target”
on page 70.