Western Digital WD TV Live Hub Media Center User Manual - Manual (Page 19)

WD TV Live Hub Media Center
User Manual
GETTING STARTED – 14
Component Video and Audio (High Definition)
The component connection only provides video signals. You will also need to
connect the composite audio cables to provide sound. This interface provides video
quality resolution of up to 1080i.
To connect your media center using component and audio cables:
1. Plug component cable connectors into the component jacks on the media
center.
2. Plug the opposite ends into the component ports on your TV or audio/video
system (if available), red to red, green to green, and blue to blue as shown below.
3. For audio, plug audio cable connectors into the audio jacks on the media center.
4. Plug the audio connectors on the opposite end of the cable into the audio input
jacks on your TV, red to red and white to white.
Wait a few seconds for your TV to detect the media center. If the media center is
not detected, you may need to change the input source on your TV to
component. Check the user documentation of your TV for more information.
Once the media center is detected, the splash screen displays to indicate system
bootup, then the home screen of the user interface opens.
Note: Component and audio cables are sold separately.