Western Digital My Net N750 User Manual - Manual (Page 32)

BASIC SETTINGS AND TASKS
28 MY NET ROUTERS
USER MANUAL
To connect a WPS-enabled device:
1. Click the Click here to connect using WPS link to display the screen shown below:
2. Select one of the two WPS methods:
a. Method 1: Press the WPS button on the front of the router or click the virtual button on this
screen. On your wireless device, press the physical
WPS button or click the virtual WPS
button.
b. Method 2: If prompted by your wireless device, enter the router’s WPS PIN shown on the
screen into your wireless device.
Note: The label on the bottom of the router displays the default PIN. You can
change the PIN on the Wi-Fi Protected Setup screen. (See “Advanced
Wireless Category” on page 36.) Once you change the PIN, the default
value is invalid unless you reset the router to default values.
3. Click Next.
To connect a device that is not WPS enabled:
1. On the Add a Device screen, click the Click here to connect by entering network
name and password key.