Wolo 3700P SERIES Priority 2 - Manual (Page 2)

Wolo Manufacturing Corp. , One Saxwood Street, Deer Park, NY 11729
Attn: Warranty Service E-mail: [email protected]
© 2007 Wolo Mfg. Corp.
All Rights Reserved.
Warranty
Wolo Manufacturing Corporation (“Wolo”) warranties to the original purchaser, for three months from the date of purchase, that
the product is free from defects in workmanship and materials. If there is such a proven defect, Wolo, at its option, will either repair
or replace the item free of charge, if it is returned to Wolo within three months from the date of purchase together with proof of
purchase as described below. Wolo reserves the right to inspect any defect prior to settling any warranty claim by repair or
replacement. This warranty is limited as above provided and Wolo will not be responsible for fire or other casualty or accident,
due to neglect, abuse, abnormal use, modifications, faulty installation of this product, or natural causes.
ANY EXPRESSED WARRANTY NOT PROVIDED HEREIN IS EXCLUDED AND DISCLAIMED. THE IMPLIED WARRANTIES OF
MERCHANTABILITY AND OF FITNESS FOR A PARTICULAR PURPOSE ARE EXPRESSLY LIMITED TO A TERM OF THREE (3)
MONTHS. UNDER NO CIRCUMSTANCES SHALL WOLO BE LIABLE TO PURCHASER OR ANY OTHER PERSON FOR ANY
SPECIAL OR CONSEQUENTIAL DAMAGES, WHETHER ARISING OUT OF BREACH OF WARRANTY OR OTHERWISE.
To obtain warranty service, return the product prepaid, and include the original bill of sale showing the date of purchase. Provide with the return a
brief description of the problem. Also, include with the return a check or money order in the amount of $20.00 to cover return shipping. Mail to:
20. The base of the bulb has two tabs, press inward and remove the bulb by lightly pushing the base side to side while lifting
upward.
21. Insert the replacement bulb into PC board socket that the bad bulb was removed from and push downward on the bulb’s
base. Make sure the tabs of the bulb’s base engage into the slots of the PC board.
22. Place the clear fresnel lens back into position and secure by turning the lens clockwise until tight.
23. The outer lens is placed back onto the lightís base and secured with the four screws. CAUTION: to prevent damage or
cracking of the lens, tighten screws evenly and do not over tighten.