WORX WU462 720W Jigsaw 240V - Manual (Page 10)

10
Chart 1
Material Speed setting
Wood 5-6
Metal 3-4
Aluminium 3-5
PVC 3-4
Ceramic 3-5
HaND GRiP aReaS
Always ensure you maintain a firm grip whilst operating your jigsaw.
DUSt coveR (See fig. c1, c2)
Mount the dust cover (16) onto the machine in such a manner that
the holders in the centre of the dust cover engage on the protection
finger (13). To remove the dust cover (16), grasp it by the side and
pull it off toward the front.
Note:Use the dust cover only with a mitre angle of 0°.
BlaDe fittiNG
You can only use the blade type shown in Fig D. To open the blade
holder, briefly press the SDS clamping mechanism (14) and hold in
position (See Fig. E1, E2). Then fully insert the blade into the blade
holder slot with blade teeth facing forward and release the ring,
which will self rotate and clamp over the top of the blade. Push the
blade into the blade holder again to ensure it is locked in position.
Ensure the edge of the blade is located in the groove of the roller
guide (See Fig. F).
warning: Blade teeth are very sharp. for best cutting
4
5
6
1 2 3 4
5 6 7 8 9 10 11
12
13
14
15
16
1
2
13
14
a
B A
E1 D
C2 C1
e d 10
6
17
9
c
b
8
7
d 5
14
J2 J1
L1 K
L2
F E2
I H2
H1 G