WORX WU462 720W Jigsaw 240V - Manual (Page 12)

12
retainer (8) superposition at the desired angle (b) (0°,15°,30°,45°).
For other mitre angles, rotate to your desired angle (use a protractor
scale). Following one of the above procedures, hold the base plate
in position and firmly tighten the bolts to clamp the base plate at that
angle. Finally, check the angle and ensure the base plate is firmly
clamped. The angle markings on the base plate are accurate for most
general purposes but it is recommended for accurate work to set the
angle with a protractor and make a test cut on other material.
(See Fig. H1)
For sawing close to edges, the base plate can be offset to the rear.
Remove the dust cover. Release the clamping bolts of the base plate
and push the base plate toward the mains cable to the stop.Close
the base plate clamping bolts to lock the base plate in the adjusted
position. Sawing with the base plate offset is possible only with a
mitre angle of 0°. (See Fig. H2)
PlaStic foot Plate PRotectioN (See fig. i)
Your tool is equipped with base plate protection that protects finer
surface.
To attached, hook the protection over front of base plate and snap
into base plate.
DUSt tUBe (See fig. J1, J2)
Mount the dust tube (5) into the opening of the base plate (7). Make
sure that the plastic tip(d) of the vacuum connection engages into the
corresponding opening(e) on the housing as shown in the figure.
PRotectioN fiNGeR
The finger is located in front of the blade holder. Whilst working, it will
help prevent accidental contact with moving blade.
11
12
13
e d 10
6
17
9
c
b
8
7
d 5
14
J2 J1
L1 K
L2
F E2
I H2
H1 G