WORX WU462 720W Jigsaw 240V - Manual (Page 15)

15
Metal cUttiNG
Use a finer tooth blade for ferrous metals and a coarse tooth blade
for non-ferrous metals. When cutting thin sheet metals always clamp
wood on both sides of the sheet to reduce vibration or tearing of the
sheet metal. Both wood and sheet metal must be cut. Do not force
the cutting blade when cutting thin metal or sheet steel, as they are
harder materials and will take longer to cut. Excessive blade force
may reduce the life of the blade or damage the motor. To reduce heat
during metal cutting, add a little lubricant along the cutting line.
Maintenance
Remove the plug from the socket before carrying out any
adjustment, servicing or maintenance.
Your power tool requires no additional lubrication or maintenance.
There are no user serviceable parts in your power tool. Never use
water or chemical cleaners to clean your power tool. Wipe clean with
a dry cloth. Always store your power tool in a dry place. Keep the
motor ventilation slots clean. Keep all working controls free of dust.
Occasionally you may see sparks through the ventilation slots. This is
normal.
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in order
to avoid a hazard.
Environmental protection
Waste electrical products should not be disposed of with
household waste. Please recycle where facilities exist. Check
with your local authorities or retailer for recycling advice.