WORX WU462 720W Jigsaw 240V - Manual (Page 9)

9
1
2
3
Operating instructions
Note: Before using the tool, read the instruction book carefully.
iNteNDeD USe
The machine is intended for sawing wood, plastic, metal and building
materials while resting firmly on the workpiece. It is suitable for
straight and curved cuts with mitre angles to 45°. The saw blade
recommendations are to be observed.
oN/off SwitcH
Depress to start and release to stop your tool.
lock-oN BUttoN
Depress on/off switch (1) then lock-on button (2) (See Fig. A), release
on/off switch first then lock-on button second. Your switch is now
locked on for continuous use. To switch off your tool just depress and
release on/off switch.
vaRiaBle SPeeD coNtRol
The variable speed control is at the rear of the machine. Adjust the
variable speed control to increase or decrease the speed (See Fig. B)
according to the material, material thickness and blade specification
to be used (also possible during no load operation). See Chart 1 for
general guidance on speed selection.
Avoid prolonged use at very low speed as this may damage your
jigsaw’s motor.
1 2 3 4
5 6 7 8 9 10 11
12
13
14
15
16
1
2
13
14
a
B A
E1 D
C2 C1