WORX WU462 720W Jigsaw 240V - Manual (Page 11)

11
results ensure you use a blade suited to the material and cut
quality you need.
RolleR GUiDe
Ensure the blade is located and runs smoothly in the groove
(See Fig. F) otherwise the pendulum function will not work correctly
and the blade will not be supported during cutting.
PeNDUlUM actioN coNtRol
The pendulum action varies the forward cutting angle of the blade for
increased cutting efficiency. This can also be adjusted during no load
running. Refer to the chart 2 for more details. Do not use excessive
blade force when cutting with the pendulum action. The blade cuts
on the upward stroke only (See Fig. G).
Chart 2
0 Thin materials. Fine cuts. Tight curves.
I Hard materials, (e.g. steel & chipboard).
II Thick materials (e.g. wood) & plastic.
III
Fast cuts (e.g. softwood). Cutting in the direction of the
wood grain.
BaSe Plate
Adjusting the angle of the base plate enables bevel cutting. The base
plate must always be held firmly against the materials being cut to
reduce saw vibration, blade jumping or blade breakage.
BaSe Plate aNGle aDJUStMeNt(See fig. H1, H2)
Use a hex key (4). Loosen the bolts (c) securing the base plate. For
preset angles rotate so the lines of the angle on the base plate and
7
8
9
10
e d 10
6
17
9
c
b
8
7
d 5
14
J2 J1
L1 K
L2
F E2
I H2
H1 G