Yamato Scientific Vacuum controller Vacuum controller - Manual (Page 21)

19
Using the Function Menu
‹ The function menu is accepted either before or during operations.
‹ The measurement calibrating system is programmed in the function menues of the fixed
value control mode and of the free mode. The calibration mode is accepted before a control
starts,or,while a control operates.
‹ There are 「Ramp time edit」and 「Pressure ramp level edit」system in the ramp control as
a series.
‹ When FUNCTION MENU is pressed again, just before ENTER is pressed to decide values;
☆ Function selectings and set point editings, which has been done in the function menu,are
stopped.
☆ Operations, which has been running untill FUNCTION MENU was pressed, are returned.
The set point which was decided during editing is restored.
‹ If there is no key operations for ten seconds after FUNCTION MENU was pressed, the
indication is returned to the original state.