Battery information, Viewing your video, Transmitter specifications – 3D Robotics RTF Aero OSD User Manual

Page 4

Advertising
background image

Battery information

The transmitter and receiver are powered by 3-cell 11.1 V 900 mAh lithium

polymer (LiPo) batteries. Please charge the batteries before each use. Each

full battery provides approximately two hours of operation for your OSD/FPV

system.

Protect battery from extreme heat, extreme cold, puncturing, and flammable

surfaces. Charge battery using a designated LiPo balance charger only. Always

monitor battery while charging, and always fly with a fully charged battery.

Inspect battery for damage before takeoff and after landing. If you observe

any swelling of the package or the battery ceases to function, locate your local

battery recycling center to dispose of the battery. In the US and Canada, visit

call2recycle.org to find a location. Do not dispose of the battery in the trash.

Viewing your video

Power your vehicle, and connect the batteries to the transmitter and receiver to

activate your OSD/FPV setup.

We recommend the following devices for displaying the video transmitted by your

3DR Video Kit.

»

FPV monitors are a great, portable solution for viewing your video at the field.

Purchase a monitor/receiver compatible with your kit at

store.3drobotics.com

.

»

Turn your computer into a video capturing platform with

this AV-USB adapter

.

(This solution requires an AV male-to-male adapter.)

Transmitter specifications

»

5.8 GHz 200 mW wireless AV transmitter:

»

Transmitter frequency / channel amount: 5705-5945 MHz / 8 CH

»

Output power: 200 mW/33 dBm

»

Frequency control: Built-in frequency & phase lock loop

»

AV input: analog AV signal input

»

ANT connector: RP-SMA

»

Power supply: DC 7-12 volts

»

Current supply: 850 mA

»

Size: 68*26*28 mm

»

Weight: 60 g (including antenna)

»

Gross weight: 85 g

Advertising
This manual is related to the following products: