Rockwell Automation 20P PowerFlex DC Drive - Frame A Bimetal Thermostat - Manual

Installation Instructions
PowerFlex
®
DC Drive - Frame A Bimetal
Thermostat
What This Kit Includes
•
Bimetal Thermostat
•
Two screws
•
Wire leads with connector
•
Thermal grease
•
Static strap
Tools That You Need
•
Phillips
®
screwdriver
•
Flathead screwdriver
Phillips
®
is a registered trademark of Phillips Screw Company.
What You Need to Do To install the Bimetal Thermostat:
❐ Step 1: Remove power from the drive
❐ Step 2: Remove the protective covers
❐ Step 3: Remove the Control EMI shield and Control board
❐ Step 4: Remove the Pulse Transformer and Switching Power Supply
boards
❐ Step 5: Remove the existing Bimetal Thermostat
❐ Step 6: Install the new Bimetal Thermostat
❐ Step 7; Install the Pulse Transformer board and Switching Power
Supply board
❐ Step 8: Install the Control EMI Shield and Control board
❐ Step 9: Replace the protective covers and document the change
ATTENTION: Only qualified personnel familiar with DC
drives and associated machinery should plan or implement the
installation, start-up and subsequent maintenance of the system.
Failure to comply may result in personal injury and/or equipment
damage.
ATTENTION: To avoid an electric shock hazard, ensure that
all power to the drive has been removed before performing the
following.
ATTENTION: This drive contains ESD (Electrostatic
Discharge) sensitive parts and assemblies. Static control
precautions are required when installing, testing, servicing or
repairing this assembly. Component damage may result if ESD
control procedures are not followed. If you are not familiar with
static control procedures, reference A-B publication 8000-4.5.2,
“Guarding Against Electrostatic Damage” or any other
applicable ESD protection handbook.