Rockwell Automation PF700 Power Interface Board and SMPS Board Replacement - Frames 7, 8, 9, 10 - Manual (Page 14)

14 Publication 20B-IN22B-EN-P — December 2009
Chapter 2 Component Replacement Procedures
Power Interface Board Remove Components
1. Perform Remove Main Control Panel Assembly on page 13 .
2. Remove all remaining wiring and cabling from the Power Interface
Board as indicated in the table below.
Connector
Frame
Connected Components
7 8 9 10
J1 X X X X Main Control Board
J10 X X X Precharge Board (only on DC input systems)
J8 X X X U Phase Gate Interface Board
J9 X X 24V Power Supply Board
J16 X X X X W Phase CT
J15 X X X X V Phase CT
J14 X X X X U Phase CT
J24 X X X X +Bus IN of Power Interface Board
to J1 of Precharge Board
J13 X X X X Switch Mode Power Supply Board
J12 X X X X Switch Mode Power Supply Board
J23 X X X X U, V, W positive gates (upper phase)
J18 X X X X U, V, W negative gates (lower phase)
TB2 X X X X TB11
J7 X Monitor Wire to thermal sensors
J6 X X X Monitor Wire to thermal sensors
TB1 X X X X TB11
J2 X X X Switch Mode Power Supply Board
Frame 9
DC input
shown
J1
J10
J8
J9
J16
J15
J14
J24
J13 J12
J23
J18
TB2
J6
TB1
J2
J7