Rockwell Automation PF700 Power Interface Board and SMPS Board Replacement - Frames 7, 8, 9, 10 - Manual (Page 7)

Preface
Publication 20B-IN22B-EN-P — December 2009 7
ATTENTION
This assembly contains parts and sub-assemblies
that are sensitive to electrostatic discharge. Static
control precautions are required when servicing this
assembly. Component damage may result if you
ignore electrostatic discharge control procedures. If
you are not familiar with static control procedures,
reference Allen-Bradley Publication 8000-4.5.2
Guarding Against Electrostatic Damage, or any other
applicable ESD protection handbook.
ATTENTION
The information in this publication is merely a guide
for proper installation. Rockwell Automation, Inc.
cannot assume responsibility for the compliance or
the noncompliance to any code (national, local, or
otherwise) for the proper installation of this drive or
associated equipment. A hazard of personal injury
and/or equipment damage exists if codes are
ignored.
ATTENTION
Only qualified personnel familiar with adjustable
frequency AC drives and associated machinery
should plan or implement the installation, start-up,
and subsequent maintenance of the system. Failure
to comply may result in personal injury and/or
equipment damage.
ATTENTION
HOT surfaces can cause severe burns.
Do not touch
the heatsink surface during operation of the drive.
After disconnecting power, allow time for cooling.
ATTENTION
Replace all protective shields before applying power
to the drive. Failure to replace protective shields
may result in death or serious injury.