Rockwell Automation 20P PowerFlex DC Drive - Frame A SCR Modules for Drives with Bus Bars - Manual (Page 17)

PowerFlex® DC Drive - Frame A SCR Modules for Drives with Bus Bars 17
Step 8: Install the Bus
Bars Install the bus bars in reverse order of removal as detailed in Step 5:
Remove the Bus Bars on page 11 .
Use the following table to determine the proper tightening torque for the bus
bars to SCR Modules connections.
Step 9: Install the Pulse
Transformer and Switching
Power Supply Boards Install the Pulse Transformer and Switching Power Supply boards in reverse
order of removal as detailed in Step 4:
Remove the Pulse Transformer and
Switching Power Supply Boards on page 7 .
Step 10: Install the Control
EMI Shield and Control
Board Install the Control EMI Shield and Control board in the reverse order of
removal as detailed in Step 3:
Remove the Control EMI Shield and Control
Board on page 5 .
230V AC Input 460V AC Input
Part Number Final Torque Part Number Final Torque
SK-20P-S7F46 2.5…4 N•m (22…35.4 lb•in) SK-20P-S7F75 2.5…4 N•m (22…35.4 lb•in)
SK-20P-S7F47 2.5…4 N•m (22…35.4 lb•in) SK-20P-S7F77 2.5…4 N•m (22…35.4 lb•in)
ATTENTION: Each gate lead cable must be connected to the
exact connector from which it was removed on the Pulse
Transformer circuit board or damage to the drive may occur.