Rockwell Automation 22-XCOMM-DC-BASE DSI External Communications Kit - Manual (Page 2)

2
Panel Mounting Using the Dimensional Drawing
Mount the Comms Kit to a panel using two M4 or #8
panhead screws (not included).
Figure 2 shows mounting
dimensions.
Figure 2 Panel Mounting Dimensions
Panel Mounting Procedure Using Comms Kit as a Template
The following procedure enables you to use the assembled
Comms Kit as a template for drilling holes in the panel.
1. Using the assembled Comms Kit as a template, carefully
mark the center of both holes on the panel.
2. Remove the Comms Kit to a clean location.
3. Drill and tap the mounting holes for the recommended
M4 or #8 panhead screws (not included).
4. Place the Comms Kit back on the panel, and check for
proper hole alignment.
5. Attach the Comms Kit to the panel using the mounting
screws.
DIN Rail Mounting
The Comms Kit can be mounted using these DIN rails:
• 35 x 7.5 mm (EN 50 022 - 35 x 7.5)
• 35 x 15 mm (EN 50 022 - 35 x 15)
Before mounting the Comms Kit on a DIN rail, open the
DIN rail latch. Press the DIN rail mounting area of the
Comms Kit against the DIN rail, and manually lock the DIN
rail latch (
Figure 3 ).
Figure 3 DIN Rail Mounting
Electrical Connections
After the communication adapter is installed and the
Comms Kit is mounted, make all required electrical
connections. See
Figure 4 and its related table showing the
connectors and their connection procedures.
Figure 4 Connecting to the Comms Kit
96.3 mm
(3.79 in.)
85.3 mm
(3.36 in.)
Ø 4 mm
(0.16 in.)
PORT
MOD
NET A
NET B
!
ATTENTION: Risk of equipment damage,
injury or death exists. Unpredictable operation
may occur if you fail to verify that parameter
settings and switch settings are compatible with
your application. Verify that settings are
compatible with your application before applying
power to the drive.
Item Description Connection Procedure
➊ Network
Connector Connection for the network. Insert the network
cable plug into the mating connector on the
communications adapter.
+ -
DSI Serial
DC
ADP DC + -
➊
➎ ➍ ➌ ➋