Rockwell Automation 20P PowerFlex DC Drive - Frame C Field Snubber Circuit Board - Manual

Installation Instructions
PowerFlex
®
DC Drive - Frame C Field Snubber
Circuit Board
What This Kit Includes
•
Field Snubber circuit board
•
Seven screws and captive washers (for Field board)
•
Cables for connectors X3 and XFCD (on Field board)
•
Static strap
Important: It is highly recommended that the Field SCR module and Dual
Diode module be replaced when replacing the Field circuit
board. The Field SCR and Dual Diode modules are sold as
separate spare part kits.
Tools That You Need
•
Phillips
®
screwdriver
•
Flathead screwdriver
Phillips
®
is a registered trademark of Phillips Screw Company.
!
ATTENTION: Only qualified personnel familiar with DC
drives and associated machinery should plan or implement the
installation, start-up and subsequent maintenance of the system.
Failure to comply may result in personal injury and/or equipment
damage.
!
ATTENTION: To avoid an electric shock hazard, ensure that
all power to the drive has been removed before performing the
following.
!
ATTENTION: This drive contains ESD (Electrostatic
Discharge) sensitive parts and assemblies. Static control
precautions are required when installing, testing, servicing or
repairing this assembly. Component damage may result if ESD
control procedures are not followed. If you are not familiar with
static control procedures, reference A-B publication 8000-4.5.2,
“Guarding Against Electrostatic Damage” or any other
applicable ESD protection handbook.