Rockwell Automation 20P PowerFlex DC Drive - Frame C Field Snubber Circuit Board - Manual (Page 4)

4 PowerFlex® DC Drive - Frame C Field Snubber Circuit Board
3. Loosen, but do not remove, the screws that secure the top cover to the
drive, then slide the cover up and off the drive chassis.
Important: The HIM assembly is connected via a cable to the Control
board and therefore will not pull free from the drive until
disconnected. See step 4 below for instructions.
4. Disconnect the HIM Communication cable from the connector on the
upper right corner of the Control board and set the cover aside.
STS
PORT
MOD
NET A
NET B
FU1 FV1
U V
C D
W
Tightening torque:
1.5 N-m (13.3 lb.-in.)
Pull tabs out
to disconnect
cable.