Rockwell Automation 440G-TLSZR-L-GD2 Guard Locking Switch - Manual (Page 3)

TLSZR/L-GD2
10000302608 Ver 00 July 2012 3
Installation Instructions
Installation must be in accordance with the following steps and stated specifications and should
be carried out by competent personnel. The unit is not to be used as a mechanical stop. Guard
stops and guides must be fitted. Adherence to the recommended maintenance instructions forms
part of the warranty.
This device is intended to be part of the safety related control system of a machine. Before
installation, a risk assessment should be performed to determine whether the specifications of
this device are suitable for all foreseeable operational and environmental characteristics of the
machine to which it is to be fitted. Refer to Technical Specifications for certification information
and ratings.
Use nonremovable screws, bolts, or nuts to mount the switch and actuators. Do not over torque
the mounting hardware.
For use with flexible actuator only, 440G-A27143.
IMPORTANT: SAVE THESE INSTRUCTIONS FOR FUTURE USE
Target
Actuator
TLSZR/L-GD2
Switch
Target
Alignment
Marks