Rockwell Automation 20G PowerFlex 750-Series Power Jumpers - Manual (Page 5)

Rockwell Automation Publication 750-IN011E-EN-P - February 2014 5
PowerFlex 750-Series Power Jumpers
Jumper Locations and
Settings The following pages show jumper locations and settings.
Frame Vo
lt
ag
e
Code
Factory Default Jumper Settings
Power Source Type Catalog Code “A” Catalog Code “J”
1 C
D
PE-A jumper wire
connected to ground.
PE-B jumper wire
insulated/
disconnected from
ground. PE-A jumper wire
and PE-B jumper
wire connected to
ground. Solid Ground
Connect the MOV/Input Filter Cap jumper wire (PE-
A) and the CM Cap jumper wire (PE-B) to ground.
Non-Solid Ground
Insulate the MOV/Input Filter Cap jumper wire (PE-
A) and the CM Cap jumper wire (PE-B) from
ground.
2 C
D
PE-A Installed
PE-B Not Installed PE-A Installed
PE-B Installed Solid Ground
Install jumper screws at “PE-A” (MOV/Input Filter
Cap) and “PE-B” (CM Cap).
See
page 4 for recommended torque.
Non-Solid Ground
Remove both jumper screws.
3 C
D
E
PE-A Installed
PE-B Not Installed PE-A Installed
PE-B Installed Solid Ground
Install jumper screws at “PE-A” (MOV/Input Filter
Cap) and “PE-B” (CM Cap).
See
page 4 for recommended torque.
Non-Solid Ground
Remove both jumper screws.
4 C
D
E
PE-A Installed
PE-B Not Installed PE-A Installed
PE-B Installed Solid Ground
Install Jumper screws at “PE-A” (MOV/Input Filter
Cap) and “PE-B” (CM Cap).
See
page 4 for recommended torque.
Non-Solid Ground
Remove both jumper screws.
PE-A
PE-B
Insulated
Connected
Insulated
Connected
PE-B
PE-A
PE-B
PE-A
PE-B
PE-A