Rockwell Automation 1512B MV Controllers, 200/400A Two-High Cabinet, Standard and Arc-Resistant Enclosure - Manual (Page 20)

12 Rockwell Automation Publication 1500-UM055G-EN-P - May 2013
Chapter 2 Installation – Standard Enclosure
3. Open the low voltage cell doors (refer to Opening the Low Voltage Doors
on page 5 ).
4. Disconnect the control wiring harness from the wire plug at the lower left
side of the contactor.
5. Remove the two self-tapping screws from the center vertical channel (see
Figure 10 ).
6. Pull on the center vertical channel to swing out the low voltage panel.
Figure 10 - Center Vertical Channel
Remove self-tapping screws
from center vertical channel
Control Wiring Harness