Rockwell Automation 1608M MegaDySC User Manual, 208 Volt, One Second Extended Runt - Manual (Page 29)

Rockwell Automation Publication 1608M-UM004A-EN-P - April 2014 29
Chapter
6
Display Screen
Overview
The MegaDySC® touch screen display is a window to voltage sags and
MegaDySC protection. The display provides system status, voltage sag
notification and history, runtime statistics and system history in a simple and
intuitive touch-based user interface.
When the system first starts, a welcome screen displaying the MegaDySC
product logo appears. This screen disappears after 5 seconds, when the “Home”
screen appears.
Note: The touch screen is optimized for use with a plastic stylus or bare finger.
At installation time perform the following
steps to configure your system:
Step 1: Press the “CONFIG” button
at the bottom of the “HOME” screen
(See
Figure 10 ).
Figure 10 - Home Screen
Step 2: Begin calibration by pressing
“CALIBRATE TOUCH SENSOR”
(See
Figure 11 ).
Figure 11 - System Configuration