Rockwell Automation 1403-NENET Ethernet Communication Card Installation Instructions - Manual (Page 6)

Publication 1403-IN005A-EN-P
2 Product Description
Features The Ethernet Communication Card features include:
•
Connect to Allen-Bradley PLC-5
®
Ethernet processors
•
Connect to Allen-Bradley SLC 5/05 ™ Ethernet processor
•
Built-in internet web page support
•
Compatible with RSEnergy™, RSView32 ™ and RSPower32™
software
•
Ethernet communication rate: 10Mbps
•
Compatible with commercially available network bridges and routers
•
Fully software configurable
•
Supports RSLinx ™ and WINtelligent Linx ™ (emulates SLC 500 ™ )
Figure 1 Catalog Number 1403-NENET Communications Module
Installation
1. Remove Master Module control power.
2. Remove the blank plate by unscrewing the two corner retaining screws
as shown i nFigure 2. Save these two screws for assembly.
Captive Fastening Screw
Finger Hold
Internal RS-232 Connector
10BT Connector
Internal 10B5 Connector
Receive (RX) LED
Transmit (TX) LED
Ready (RDY) LED
Link (LK) LED
ATTENTION
!
Please follow appropriate ESD procedures before removal
and/or installation of the Ethernet Communications Card.
Failure to follow these procedures can result in physical
damage to both the Ethernet Communications Card and
the Master Module.