Rockwell Automation 1609-B_D UPS Product User Manual - Manual (Page 11)

Rockwell Automation Publication 1609-UM009A-EN-P - January 2013 11
Bulletin 1609 UPS
1609-B Installation Instructions
Battery Wiring
and Installation Note: Batteries are not included with the 1609-B UPS
1. To access the battery compartment remove the three screws and the
battery door.
2. Remove the battery container, jumpers, and wire harness from the battery
compartment. Place the battery container and batteries onto a flat surface.
Use the provided jumper wires to connect the batteries in series. Connect
the positive terminal (red) of the battery to the negative terminal (black)
of another battery. Connect the red wire of the harness to the positive
terminal (top red) and the black wire of the harness to the negative
terminal (bottom black). See photo below for details.
3. Fold the battery container and seal it with tape.
ATTENTION: Disconnect the 1609-SPD before servicing, due to electric shock
hazard for risk of severe injury or death.