Rockwell Automation 931S-C4C5D-BC Active Converter - Manual (Page 2)

1. General instructions
• Disconnect power prior to installation
• Installation only by Qualified personnel
• Follow all applicable local and national electrical codes
• Due to potential hazardous voltages in close proximity, use a non-
conductive tool and proper PPE when adjusting the potentiometers
on the front panel.
For applications with high isolation voltages, take measures to prevent
accidental contact and make sure that there is sufficient distance or
insulation between adjacent devices!
Appropriate safety measures against electrostatic discharge
(ESD) should be taken during assembly and adjustment work
on the 931S-C4C5D-BC.
2. Application
The 3 Way Active Converters 931S-C4C5D-BC are used for galvanic
isolation and conversion of signals in the range from ±20 mV to ±200 V and
±0.1 mA to ±100 mA. Depending on the model, input and output signals
are permanently set or you can select calibrated ranges by means of
DIP switches. The preset measuring ranges do not have to be fine adjusted.
Other transmission ranges are infinitely adjustable within the ranges
mentioned above using potentio meters. Signal transmission is linear.
By means of the broad-range mains adapter, the units can be powered by
voltages from 22 to 230 V AC/DC.
2
WARNING WARNING