Rockwell Automation 931S-C4C5D-BC Active Converter - Manual (Page 3)

3
3. Configuration
3.1 Equipment
A screwdriver with a width of 2.5 mm is required to adjust the unit and to
connect the wires to the terminals.
3.2 Opening the unit
Disconnect the plugs. Disengage the top
part of the housing by carefully pressing the
latches on both sides (1). Pull out the top
part of the housing and the electronics
section until they unlock (2).
3.3 Settings
Set the input and output ranges, offset and
bandwidth using DIP switches S1, S2 and S3 as
indicated in the following tables. When selecting
a variable amplification or offset setting, an
additional adjustment can be made using the
Span (amplification) or Zero (offset) potentio -
meters located under the top cover (3).
1
2
1
3
Span
Zero
S1 S2
S3