Rockwell Automation H-Series Servo Motor - Manual (Page 3)

H-Series Motor Installation Instructions 3
Publication 1398-IN517A-EN-P — August 2001
Before You Install the Motor
Before installing or storing the motor:
1. Remove the motor carefully from its shipping container.
2. Visually inspect the motor for any damage.
3. Examine the motor frame, front output shaft, and mounting pilot for
any defects.
4. Notify the carrier of any shipping damage immediately.
Using Shaft Seals
An additional seal is required on the motor shaft near the motor front
bearing, if the shaft is exposed to fluids or significant amounts of fine
dust. This includes lubricating oil from a gearbox. The motor ingress
protection (IP) rating depends on the usage of shaft seals and
environmentally sealed connectors/cables. The additional seal is not
recommended in applications where the motor shaft area is free of liquids
or fine dust. Refer to Shaft Seal Kits on page 17 to find the catalog number
of the seal kit for your H-Series motor.
ATTENTION
!
Do not open or attempt to open the motor.
Only a qualified Allen-Bradley employee can
service this type of motor.
Failure to observe these safety procedures could
result in personal injury or equipment damage.