Rockwell Automation H-Series Servo Motor - Manual (Page 7)

H-Series Motor Installation Instructions 7
Publication 1398-IN517A-EN-P — August 2001
Installing Your Motor
The installation must comply with all local regulations and use of
equipment and installation practices that promote electromagnetic
compatibility (EMC) and safety. Preferred fasteners are stainless steel.
ATTENTION
!
Unmounted motors, disconnected mechanical
couplings, and/or disconnected cables are
dangerous if power is applied.
Disassembled equipment should be appropriately
identified (tagged-out) and access to electrical
power restricted (locked-out).
Before applying power to the motor, remove the
shaft key and other mechanical couplings which
could be thrown from the shaft.
Failure to observe these safety procedures could
result in personal injury or equipment damage.
ATTENTION
!
An H-Series Personality Module must be installed
on servo drives requiring a Personality Module.
Rapid shaft rotation up to one revolution may
occur when the drive is enabled, if an H-Series
Personality Module is not installed.
Failure to observe these safety procedures could
result in personal injury or equipment damage.