Rockwell Automation 1609-ENET Ethernet Network Card Quick Start - Manual (Page 9)

Rockwell Automation Publication 1609-QS002A-EN-P - May 2014 9
Web Mode Setup Chapter 2
5. Use the PING utility to check the connection between your PC and the ENET card. From Windows, launch the
Command Prompt and enter ping 192.168.1.100. You should receive replies. Note: Make sure your computer is on
the same network as the UPS with a static IP address.
6. Launch your web browser.
7. Type the 1609-ENET IP address “192.168.1.100” in the address bar and press enter.
8. Type the username and password. “Username: admin / Password: password”