Rockwell Automation 1734-VHSC24 Very High-Speed Counter Modules User Manual - Manual (Page 64)

Publication 1734-UM003B-EN-P - August 2005
A-6 Configure Modules in RSLogix 5000 Software
Work with the Counter
Configuration Dialog In Hard Run mode, you disable all controls on the Counter
Configuration dialog, in addition to the enable and disable state for
each control.
Use the following procedures to complete entries from this dialog.
After you select Type, refer to the table to see what other entries are
available in the dialog.
.
These
Entries Are Available If You Select This For Type
Counter Encoder
X1, X2, X4 PWM Period/Rate Continuous/
Rate Rate
Measurement Pulse
Generator
Store Count Mode X X
Rollover X X Set to Zero
Counter Attenuator X X X
Frequency Precision X X X
Time Base/Gate Interval X X
Invert Input Z X X X X X
Scalar X X X