Rockwell Automation 1784-PCM2/B CABLE Installation Instructions - Manual (Page 2)

1784-PCM2/B Cable 2
Publication 1784-5.22 – January 1997
Attach the Wedges
!
ATTENTION: You must attach the wedge that is
provided with your cable to the computer. This wedge
provides strain relief for the cable and secures the cable to
the computer so the cable is not accidently disconnected.
If you do not use the wedge and the cable disconnects, it
can damage the connector on the cable and PCMK card.
1. Slide the wedge into the slot on the bottom of the cable’s electronics
pod as shown below.
19875
electronics pod
2. Position the assembly on the computer so the narrow end of the
wedge is closest to the PCMCIA slot. When you find the best location
for the wedge, use a pencil to mark the location on the computer.
length of cable from
connector to electronics
pod is17.8 cm (7 in.)
19875-M