Rockwell Automation 1792D-4BT4LP INSTL INSTR ARMORBLOCK LP2 - Manual (Page 2)

2 4 Sinking Input / 4 Output Module
Publication 1792D-5.26 - January 1999
European Union Directive Compliance
If this product has the CE mark it is approved for installation within the
European Union and EEA regions. It has been designed and tested to meet
the following directives.
EMC Directive
This product is tested to meet Council Directive 89/336/EEC
Electromagnetic Compatibility (EMC) and the following standards, in
whole or in part, documented in a technical construction file:
• EN 50081-2 EMC - Generic Emission Standard, Part 2 - Industrial
Environment
• EN 50082-2 EMC - Generic Immunity Standard, Part 2 - Industrial
Environment
This product is intended for use in an industrial environment.
Low Voltage Directive
This product is tested to meet Council Directive 73/23/EEC Low Voltage,
by applying the safety requirements of EN 61131-2 Programmable
Controllers, Part 2 - Equipment Requirements and Tests.
For specific information required by EN 61131-2, see the appropriate
sections in this publication, as well as the following Allen-Bradley
publications:
• Industrial Automation Wiring and Grounding Guidelines For Noise
Immunity, publication 1770-4.1
• Automation Systems Catalog, publication B111
Install Your ArmorBlock LP2 I/O Module
To install the module:
• Set the node address and baud rate.
• Mount the module.
• Connect the unit to the DeviceNet trunk and the auxilary power source.
• Connect the cord sets.
Set the Node Address
Set the node address using RSNetworx for DeviceNet software,
DeviceNetManager

software, or another software configuration tool. The
module is equipped with AutoBaud detect. AutoBaud lets the module read
the settings already in use on your DeviceNet network and automatically
adjusts to follow those settings.