Rockwell Automation 1793-IB16 Flex Integra Input Module Install Inst - Manual

FLEX I/O and FLEX Integra are trademarks
of Rockwell Automation
Publication 1793-5.8 - December 1999
Installation Instructions
FLEX Integra
16 Sink Input Module
(Cat. No. 1793-IB16 and -IB16S)
Module Installation
This module mounts on a DIN rail. It connects to an adapter or another
FLEX I/O or Integra module. Note: If using this module with FLEX I/O
modules, do not mount between FLEX I/O modules. Mount Integra
modules to the right of the FLEX I/O modules. To mount this module:
1. Remove the cover plug (if used) in the male connector of the unit to
which you are connecting this module.
2. Position the module on the 35 x 7.5mm DIN rail A (A-B pt. no.
199-DR1).
3. Rotate the module onto the DIN rail with the top of the rail hooked
under the lip on the rear of the module.
30869-M
A
A