Rockwell Automation 1771-OWNA Contact Output Module Installation Instructions - Manual (Page 8)

Contact Output Module 8
Publication 1771-IN038B-EN-P - August 2002
3. Make your connections to the field wiring arm as shown in the
connection diagram and Table A. (Use the label on the front of
the wiring arm to identify your wiring.)
IMPORTANT
The field wiring arm terminal identification
number is not the same as the number of the bit
which controls that output.
Connection Diagram for the 1771-OWNA DC Output Module
Output 0
Output 2
Output 4
Output 6
Not used
Output 10
Output 12
Output 14
Output 16
Not used
Output 0
Output 2
Output 4
Output 6
Not used
Output 10
Output 12
Output 14
Output 16
Not used
Common 0
Output 1
Output 3
Output 5
Output 7
Common 1
Output 11
Output 13
Output 15
Output 17
Common 2
Output 1
Output 3
Output 5
Output 7
Common 3
Output 11
Output 13
Output 15
Output 17
Note: All contacts are N.O., nonselectable.
(Actual wiring runs in this direction.)
2
4
6
8
10
12
14
16
18
20
22
24
26
28
30
32
34
36
38
40
Note: Terminals on the left are
even numbered, and terminals
on the right are odd numbered.
10539ĆI
If multiple power supplies are used, do not exceed the maximum isolation voltage.
!
ATTENTION
Miswiring or shorting the output terminals will
cause permanent damage to this module.