Install the module in the chassis – Rockwell Automation 1756-RIO ControlLogix Remote I/O (RIO) Communication Interface Module Installation Instr User Manual
Page 13
Advertising
ControlLogix Remote I/O (RIO) Module 13
Rockwell Automation Publication 1756-IN610B-EN-P - November 2010
Install the Module in the Chassis
To install the module, follow these steps.
1.
Align the circuit board with the top and bottom chassis guides.
WARNING: When you insert or the remove the module while
backplane power is on, an electrical arc can occur. This could cause
an explosion in hazardous location installations. Be sure that
power is removed or the area is nonhazardous before proceeding.
Repeated electrical arcing causes excessive wear to contacts on
both the module and its mating connector. Worn contacts may
create electrical resistance that can affect module operation.
Printed
Circuit
Board
20861
Advertising