Rockwell Automation 1747-ACNR15 ControlNet Adapter Module User Manual - Manual (Page 125)

Publication 1747-UM003A-EN-P
Understanding Your SLC 500/1746 Control System B-33
Installing the RTB
Below are guidelines for installing the RTB.
1. Be sure the color of the RTB matches the color band on the module.
2. Write the appropriate slot, chassis, and module type on the RTB label.
3. Disconnect power.
4. Align the terminal block release screws with the mating connector in the
module.
5. Press the RTB firmly onto the connector contacts.
6. Tighten the terminal block release screws. To avoid cracking the
terminal block, alternate the tightening of the screws.
ATTENTION
!!!!
Inserting a wired RTB on an incorrect module can damage
the module circuitry when power is applied.
ATTENTION
!!!!
Disconnect power before attempting to install or remove
I/O modules or their terminal blocks.