Rockwell Automation 1762-IA8 MICROLOGIX 120 VAC INPUT MODULE - Manual (Page 6)

6 MicroLogix™ 1762-IA8 120V ac Input Module
1762-IN002A-US-P
DIN Rail Mounting
The module can be mounted using the following DIN rails: 35 x 7.5 mm
(EN 50 022 - 35 x 7.5) or 35 x 15 mm (EN 50 022 - 35 x 15).
Before mounting the module on a DIN rail, close the DIN rail latch. Press the
DIN rail mounting area of the module against the DIN rail. The latch will
momentarily open and lock into place.
Use DIN rail end anchors (Allen-Bradley part number 1492-EA35 or
1492-EAH35) for vibration or shock environments.
Panel Mounting
Use the dimensional template shown below to mount the module. The preferred
mounting method is to use two M4 or #8 panhead screws per module. M3.5 or #6
panhead screws may also be used, but a washer may be needed to ensure a good
ground current. Mounting screws are required on every module.
Note: For environments with greater vibration and shock concerns, use the
panel mounting method described below, instead of DIN rail
mounting.
End Anchor
End Anchor
MicroLogix 1200
Controller
MicroLogix 1200
Expansion I/O
MicroLogix 1200
Expansion I/O
MicroLogix 1200
Expansion I/O
90
(3.54) 100
(3.94)
40.4
(1.59)
40.4
(1.59)
14.5
(0.57)
NOTE: All
dimensions are in
mm (inches). Hole
spacing tolerance:
±0.4 mm
(0.016 in.).
For more than 2 modules: (number of modules - 1) x 40 mm (1.58 in.)