Rockwell Automation 1747-AENTR SLC 500 EtherNet/IP Adapter User Manual User Manual
Page 16
10
Rockwell Automation Publication 1747-UM076C-EN-E - January 2013
Chapter 2 Install Your Adapter
Wire the RJ-45 connectors as shown.
To connect the module to the network, follow these steps:
1. Attach the cables with the RJ-45 connectors to the two Ethernet ports on
the bottom of the module.
2. Attach the other end of the cables to the devices in your network.
WARNING: If you connect or disconnect the communication cable with
power applied to this module or any device on the network, an electrical
arc can occur. This could cause an explosion in hazardous location
installations. Be sure that power is removed or the area is nonhazardous
before proceeding.
IMPORTANT
To install systems with rack extensions, you can refer to the SLC 500 Modular
Hardware Style User Manual, publication
1
8
8
1
Signal
1
TxData+
2
TxData-
3
Recv Data+
4
Reserved
5
Reserved
6
Recv Data-
7
Reserved
8
Reserved
RJ-45 connectors
1747-AENTR module bottom view
45844
RJ-45