Rockwell Automation 1786-RPFM ControlNet Modular Repeater Med-distance Fiber Module Installation Instructio - Manual (Page 11)

ControlNet Modular Repeater Medium-distance Fiber Module 11
Rockwell Automation Publication 1786-IN011C-EN-P - November 2010
Connect the Fiber Module
If you are wiring only one channel, you can use either channel 1 or channel 2.
Do these steps to connect to channel 1, receive (RX).
1. Align the knob of the cable connector with the groove of the module
connector.
2. Insert the connector into channel 1 RX.
3. Twist the receive connector until the bayonet lug locks into place.
4. Repeat these procedures to connect to channel 1, transmit (TX).
IMPORTANT Make certain the fiber cable you connect to channel 1 ( receive)
on one module is set to channel 1 (transmit) on the other module.
You can use channel 1 or channel 2 on either module.
ATTENTION: Under certain conditions, viewing the optical port
may expose the eye to hazard. When viewed under some
conditions, the optical port may expose the eye beyond the
maximum permissible exposure recommendations.