Rockwell Automation 1792D-4B0LP INSTL INSTR ARMORBLOCK INPUT - Manual (Page 4)

4 ArmorBlock LP2 4 Sinking Input Module
Publication 1792D-5.27- January 1999
Input connectors for this module are shown below.
DeviceNet Cable
Refer to the DeviceNet Cable Planning and Installation Manual (DN-6.7.2)
for more information on selecting the proper DeviceNet cable for your
application.
!
ATTENTION:
• Make sure to connect the proper color coded cables
together. DeviceNet cables should connect with
DeviceNet cables.
• Make sure all connectors and caps are securely tightened
to properly seal the connections against leaks and
maintain IP67 requirements
• For maximum noise immunity, input and output cable
return wires must be properly terminated. When inputs
and outputs are connected in loopback, return wires
should be connected together.
• I/O cable length should be less than 30 meters.
I0
I1 I2
I3
Network Status Module Status
41461
Input 0
Input 1 Input 2
Input 3
Connector A
Connector B Connector C
Connector D