Rockwell Automation 1762-OB16 Solid State 24V dc Source Output Module - Manual (Page 7)

Solid State 24V DC Source Output Module 7
Publication 1762-IN011B-EN-P - June 2013
System Assembly
The expansion I/O module is attached to the controller or another I/O module by means of a
flat ribbon cable after mounting as shown below.
TIP Use the pull loop on the connector to disconnect modules. Do not pull on
the ribbon cable.
ATTENTION
EXPLOSION HAZARD
• In Class I, Division 2 applications, the bus connector must be fully
seated and the bus connector cover must be snapped in place.
• In Class I, Division 2 applications, all modules must be mounted in
direct contact with each other as shown on Page 6. If DIN rail
mounting is used, an end stop must be installed ahead of the controller
and after the last 1762 I/O module.