Rockwell Automation 1794-VHSC 1794 FLEX I/O Very High Speed Counter Module User Manual - Manual (Page 26)

18 Rockwell Automation Publication 1794-UM010D-EN-E - July 2013
Install Your FLEX I/O VHSC Module
Install the Module Installation of the module consists of:
• mount the terminal base unit
• install the 1794-VHSC module into the terminal base unit
• install the connecting wiring into the terminal base unit
If you are installing your module into a terminal base unit that is already installed,
proceed to See
Mount on a DIN Rail on page 18 .
Mount on a DIN Rail
Install the Terminal Base Unit
1. Remove the cover plug in the male connector of the unit to which you are
connecting this terminal base unit.
2. Check to make sure that the 16 pins in the male connector on the adjacent
device are straight and in line so that the mating female connector on this
terminal base unit will mate correctly.
Make certain that the female FlexBus connector is fully retracted into the
base unit.
ATTENTION: Do not remove or replace a terminal base unit when
power is applied. Interruption of the FlexBus can result in unintended
operation or machine motion.
1
2
3
4 6
7
7
8
9 0
2
+
2
+
45319